Reprotec Tufflor is a two pack Epoxy coating which provides protective and decorative properties to concrete, steel and other substrates. Often used in lean manufacturing industries for demarcation purposes
The material is supplied as a two pack epoxy system, comprising pre-weighed amounts of BASE and CURING AGENT. After mixing together, an easily applied chemical and abrasion resistant finish is produced.
As a tough, waterproof wear resistant floor coating in manufacturing areas, showrooms, trafficked warehouse areas, dry food preparation areas, breweries, abattoirs, bottling factories, etc.
Pot life @ 20°C: 45 Minutes
@ 10°C: 90 Minutes
Tack free time @ 20°C: 6 hours
Hard dry time@ 20°C: 10 hours
Full chemical resistance @ 20°C: 7 days
Adhesion strength to concrete: 3.9 MPa (concrete failure)
Adhesion strength to mild steel: >12 MPa
Chemical resistance: excellent resistance to dilute acids, dilute alkalis, oil, petrol, diesel, vegetable oils, raw sewage etc
Reprotec Tufflor is supplied in 5kg packs
Reprotec Tufflor is also supplied in 15kg packs in two colours only:-
A 5kg pack is sufficient to treat 16/20 m2 of surface area per coat we recommended a two coat treatment using either Reprotec Florprime as the first coat followed by Reprotec Tufflor, or two coats of Reprotec Tufflor, providing an overall d.f.t. of 400-500 microns. (0.4 -0.5 mm.). It is possible on a good floor that one coat of Reprotec Tufflor will give you the desired finish.
This is around £4 per square metre on a reasonable floor per coat.
one coat may be sufficient on a decent floor - two coats or a primer coat plus one top coat will always look better.
Reprotec Tufflor should be applied strictly in accordance with the manufacturer’s instructions.
Please print off and refer to the mixing and application sheet below
Please refer to Material Safety Data Sheet below for additional information
Clean Tools with Reprotec Toolclean